Description

The W5500 Ethernet Shield for Arduino from Seeed Studio is a great way to set up your projects with internet connectivity with just a single chip. Similar to the Arduino Ethernet Shield but with a newer chipset this ethernet shield supports both TCP and IP Protocols in TCP UDP ICMP IPv4 ARP IGMP and PPoE format. The RJ45ethernet port is also low enough so you can stack anothershield on top of it

The board includes a microSD card holder and has a working voltage of 5V. It also requires an Arduino to use - either Unoor Mega- to use. To learn more about this ethernet shield check out the Seeedstudio Wiki.

We recommend this library fork with the shield its just like the original Ethernet library but with W5500-chip support!

Technical Details

  • Supports Hardwired TCP/IP Protocols : TCP UDP ICMP IPv4 ARP IGMP PPPoE
  • Supports 8 independent sockets simultaneously
  • Supports Power down mode
  • Supports Wake on LAN over UDP
  • Supports High Speed Serial Peripheral Interface(SPI MODE 0 3)
  • Internal 32Kbytes Memory for TX/RX Buffers
  • 10BaseT/100BaseTX Ethernet PHY embedded
  • Supports Auto Negotiation (Full and half duplex 10 and 100* based )
  • Not supports IP Fragmentation
  • 3.3V operation with 5V I/O signal tolerance
  • LED outputs (Full/Half duplex Link Speed Active)
  • Micro-SD card socket
  • Grove connector for I2C and UART


Product Dimensions: 71.0mm x 53.0mm x 23.0mm / 2.8" x 2.1" x 0.9"

Product Weight: 25.0g/0.9oz