Description

This 5.0" TFT screen has lots of pixels 800x480 to be exact an LED backlight and a resistive touchscreen overlay. Its great for when you need a lot of space for graphics or a user interface. These screens are commonly seen in consumer electronics such as miniature TV's GPS's handheld games car displays etc. A 40-pin connector has 8 red 8 green and 8 blue parallel pins for 24 bit color capability.

This version has a 4-wire resistive touchscreen attached It's exactly the same TFT display as PID 1680 but with a resistive touch panel so it is a little more expensive.

This is a "raw pixel-dot-clock" display and does not have an SPI/parallel type controller or any kind of RAM. The display is supposed to be constantly refreshed at 60Hz with a pixel clock V sync H sync etc. There are some high end processors such as that used in the BeagleBone that can natively support such RGB TTL displays. However it is extremely rare for a small microcontroller to support it as you need dedicated hardware or a very fast processor such as an FPGA. Not only that but the backlight requires a constant-current mode boost converter that can go as high as 24V instead of our other small displays that can run the backlight off of 5V

For that reason we are carrying it only as a companion to the Adafruit RA8875 driver board in the store which is a chip that can handle the huge video RAM and timing requirements all in the background. That's the best way to interface this display to just about any microcontroller (including Arduino & friends) If you are an advanced electronics enthusiast you can try wiring this directly to your processor but it we don't have any support or tutorials for that purpose.

5.0" 40-pin TFT Display - 800x480 with Touchscreen (14:20)